RX 450h AWD V6-3.5L (2GR-FXE) Hybrid (2011)
(a) Check that the power switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Temporarily install the curtain shield airbag assembly with the 10 hooks.
NOTICE:
Do not twist the curtain shield airbag assembly when installing it.
(d) Install the 10 bolts.
Torque : 14 Nm (140 kgf-cm, 10 ft-lbf)
(e) Connect the curtain shield airbag connector.
NOTICE:
When connecting any airbag connector, take care not to damage the airbag wire harness.
2. INSTALL ROOF HEADLINING ASSEMBLY
HINT
Refer to the procedure from Install Roof Headlining Assembly See: Body and Frame/Interior Moulding / Trim/Headliner/Service
and Repair/Removal and Replacement/Installation.
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
4. PERFORM DIAGNOSTIC SYSTEM CHECK
(a) Perform a diagnostic system check See: Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes.
5. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnosis System.
Components
SUPPLEMENTAL RESTRAINT SYSTEMS: FRONT PASSENGER AIRBAG ASSEMBLY: COMPONENTS