RX 450h AWD V6-3.5L (2GR-FXE) Hybrid (2011)
(d) Connect each connector.
(e) Connect the shoulder anchor of the front seat outer belt assembly with the nut.
Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)
3. INSTALL CENTER PILLAR GARNISH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Installation
4. CONNECT FRONT SEAT OUTER BELT ASSEMBLY
(a) Install the floor end of the front seat outer belt assembly with the bolt.
Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)
(b) Check if the ELR locks.
NOTICE:
The check should be performed with the outer belt assembly installed.
(1) With the belt assembly installed, check that the belt locks when it is pulled out quickly.
5. INSTALL LOWER CENTER PILLAR GARNISH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Installation
6. INSTALL REAR DOOR SCUFF PLATE See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Installation
7. INSTALL FRONT DOOR SCUFF PLATE See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Installation
8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
9. INSTALL REAR DECK FLOOR BOX See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Installation
10. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light See: Air Bag Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnosis System.
Components
SEAT BELT: REAR SEAT INNER BELT ASSEMBLY (for LH Side): COMPONENTS