RX 450h AWD V6-3.5L (2GR-FXE) Hybrid (2011)
between other parts.
*
When the power switch is first turned on (IG) after the center airbag sensor assembly has been replaced, make sure that no one is
in the vehicle.
(d) Connect the connector to the center airbag sensor assembly as shown in the illustration.
NOTICE:
When connecting any airbag connector, take care not to damage the airbag wire harness.
(e) Check that the waterproof sheet is properly set.
(f) Check that there is no looseness in the installation parts of the center airbag sensor assembly.
2. INSTALL CONSOLE BOX See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Removal and
Replacement/Installation
3. INSTALL FRONT CONSOLE BOX COVER See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Installation
4. INSTALL REAR CONSOLE BOX ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal and
Replacement/Installation
5. INSTALL MULTI-MEDIA INTERFACE ECU ASSEMBLY (w/ USB Audio System) See: Accessories and Optional Equipment/Entertainment
Systems/Entertainment System Control Module/Service and Repair/Multi-Media Interface ECU/Installation
6. INSTALL CONSOLE REAR END PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Console/Service and
Repair/Removal and Replacement/Installation
7. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Removal and Replacement/Installation
8. INSTALL INSTRUMENT PANEL FINISH PANEL See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Installation
9. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Removal and Replacement/Installation
10. INSTALL NO. 1 SWITCH HOLE BASE See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Installation
11. INSTALL INSTRUMENT PANEL GARNISH LH See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Installation
12. INSTALL NO. 2 CONSOLE BOX DUCT See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal and
Replacement/Installation
13. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service
and Repair/Removal and Replacement/Installation
14. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Installation
15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
16. INSTALL REAR DECK FLOOR BOX See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Installation
17. PERFORM DIAGNOSTIC SYSTEM CHECK
(a) Perform a diagnostic system check See: Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes.
18. INSPECT SRS WARNING LIGHT