RX 450h AWD V6-3.5L (2GR-FXE) Hybrid (2011)
(e) Check that there is no looseness in the installation parts of the rear airbag sensor.
2. INSTALL REAR SEAT SIDE COVER See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Installation
3. INSTALL REAR DOOR SCUFF PLATE See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Installation
4. INSTALL REAR SEAT ASSEMBLY
HINT
Refer to the procedure from Install Rear Seat Assembly See: Body and Frame/Seats/Service and Repair/Removal and
Replacement/Rear Seat Assembly (for LH Side)/Installation for LH Side, See: Body and Frame/Seats/Service and Repair/Removal
and Replacement/Rear Seat Assembly (for RH Side)/Installation for RH Side).
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
6. INSTALL REAR DECK FLOOR BOX See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Installation
7. PERFORM DIAGNOSTIC SYSTEM CHECK
(a) Perform a diagnostic system check See: Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes.
8. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light See: Air Bag Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnosis System.