RX 450h AWD V6-3.5L (2GR-FXE) Hybrid (2011)
(a) Engage the 2 claws to install the No. 1 ultrasonic sensor.
NOTICE:
Push the No. 1 ultrasonic sensor retainer from the outside of the bumper when there is a gap between the retainer and the bumper
surface. In this case, do not push on the ultrasonic sensor.
HINT
The illustration is for the LH side. The RH side is the opposite of the LH side.
3. INSTALL FRONT BUMPER ASSEMBLY See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal and
Replacement/Installation
4. INSTALL HOOD CENTER CUSHION See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal and Replacement/Installation
5. INSTALL COOL AIR INTAKE DUCT SEAL See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal and
Replacement/Installation
6. INSTALL ENGINE ROOM SIDE COVER LH See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal and
Replacement/Installation
7. INSTALL ENGINE ROOM SIDE COVER See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal and
Replacement/Installation