RX 450h AWD V6-3.5L (2GR-FXE) Hybrid (2011)
Braking Sensor/Switch: Service and Repair
Removal
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: BRAKE PEDAL STROKE SENSOR: REMOVAL
NOTICE:
While the battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or
any door courtesy switch is turned on. Therefore, when servicing the brake system components, do not depress the brake pedal or
open/close the doors while the battery is connected.
1. PRECAUTION
CAUTION:
Be sure to read Precaution thoroughly before servicing See: Restraint Systems/Air Bag Systems/Service Precautions.
2. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY
HINT
Refer to the procedure from Remove Driver Side Knee Airbag Assembly See: Restraint Systems/Air Bag Systems/Air Bag/Service
and Repair/Removal and Replacement/Knee Airbag Assembly (for Driver Side)/Removal.
3. REMOVE BRAKE PEDAL STROKE SENSOR ASSEMBLY
(a) Disconnect the sensor connector.
(b) Remove the 2 bolts and brake pedal stroke sensor.
NOTICE:
Do not drop the sensor. If the sensor has been dropped, replace the brake pedal stroke sensor with a new one.