RX 450h AWD V6-3.5L (2GR-FXE) Hybrid (2011)
Distance Sensor: Service and Repair
Installation
CRUISE CONTROL: MILLIMETER WAVE RADAR SENSOR: INSTALLATION
1. INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY
(a) Tighten the 3 bolts on the millimeter wave radar sensor assembly.
Torque : 5.5 Nm (56 kgf-cm, 49 in-lbf)
HINT
Tighten the bolts in the order indicated in the illustration.
(b) Connect the connector.
2. INSTALL FRONT BUMPER ASSEMBLY See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal and
Replacement/Installation
3. INSTALL HOOD CENTER CUSHION See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal and Replacement/Installation
4. ADD WASHER FLUID (w/ Headlight Cleaner System) See: Wiper and Washer Systems/Headlamp Washer Spray Nozzle/Service and
Repair/Headlight Cleaner Actuator/Installation
5. PREPARE VEHICLE FOR FOG LIGHT AIMING ADJUSTMENT See: Lighting and Horns/Fog/Driving Lamp/Adjustments
6. PREPARE FOR FOG LIGHT AIMING See: Lighting and Horns/Fog/Driving Lamp/Adjustments
7. INSPECT FOG LIGHT AIMING See: Lighting and Horns/Fog/Driving Lamp/Adjustments
8. ADJUST FOG LIGHT AIMING See: Lighting and Horns/Fog/Driving Lamp/Adjustments
9. ADJUST MILLIMETER WAVE RADAR SENSOR See: Adjustments
10. INSTALL COOL AIR INTAKE DUCT SEAL See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal and
Replacement/Installation
11. INSTALL ENGINE ROOM SIDE COVER See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal and
Replacement/Installation
12. INSTALL ENGINE ROOM SIDE COVER LH See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal and
Replacement/Installation