RX 450h AWD V6-3.5L (2GR-FXE) Hybrid (2011)
Alignment: Service and Repair
Front Wheel Alignment ( Service Manual )
ALIGNMENT / HANDLING DIAGNOSIS: FRONT WHEEL ALIGNMENT: ADJUSTMENT
NOTICE:
If the wheel alignment has been adjusted, and if suspension or underbody components have been removed/installed or replaced, be
sure to perform the following initialization procedure in order for the system to function normally:
(a) Perform zero point calibration of the yaw rate and acceleration sensor.
1. PRECAUTION (w/ Air Suspension)
NOTICE:
Be sure to read Precaution thoroughly before servicing See: Suspension/Service Precautions/Suspension Control System.
2. INSPECT TIRES
(a) Inspect the tires See: Wheels and Tires/Testing and Inspection/Component Tests and General Diagnostics.
3. MEASURE VEHICLE HEIGHT
NOTICE:
*
Before inspecting the wheel alignment, adjust the vehicle height to the specified value.
*
Be sure to perform measurement on a level surface.
*
If it is necessary to go under the vehicle for measurement, confirm that the parking brake is applied and the vehicle is secured with
chocks.
(a) Bounce the vehicle up and down at the corners to stabilize the suspension.
(b) Measure the vehicle height.
Measurement points:
A
Ground clearance of front wheel center
B
Ground clearance of front lower suspension arm bushing set bolt center
C
Ground clearance of rear wheel center
D
Ground clearance of rear No. 2 suspension arm adjust bolt center
Vehicle Height (Unloaded Vehicle):