RX 450h AWD V6-3.5L (2GR-FXE) Hybrid (2011)
NOTICE:
*
Prevent foreign matter from attaching to the sensor tip.
*
Firmly insert the sensor body into the knuckle before tightening the bolt.
*
After installing the sensor to the knuckle, make sure that there is no clearance between the sensor stay and knuckle. Also make
sure that no foreign matter is stuck between the parts.
*
To prevent interference between the sensor and magnetic rotor, do not rotate the sensor body during or after the insertion of the
sensor body to the knuckle.
9. INSTALL FRONT AXLE SHAFT NUT See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and
Repair/Removal and Replacement/Front Drive Shaft Assembly/Installation
10. INSTALL FRONT WHEEL
Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)
11. CHECK ABS SPEED SENSOR SIGNAL
HINT
Check ABS speed sensor signal See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and
Inspection/Scan Tool Testing and Procedures/Test Mode Procedure.
12. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
HINT
Inspect and adjust the front wheel alignment See: Alignment/Service and Repair/Front Wheel Alignment ( Service Manual ).