RX 450h AWD V6-3.5L (2GR-FXE) Hybrid (2011)
NOTICE:
*
Do not bend or damage the brake line.
*
Do not allow any foreign matter such as dirt and dust to enter the brake line.
(b) Remove the clip and separate the rear flexible hose LH.
(c) Remove the bolt and separate the rear flexible hose LH from the rear upper control arm assembly LH.
37. SEPARATE REAR FLEXIBLE HOSE RH
HINT
Perform the same procedure as the LH side.
38. REMOVE REAR STABILIZER LINK SUB-ASSEMBLY (for LH Side) See: Suspension Spring ( Coil / Leaf )/Service and Repair/Removal
39. REMOVE REAR STABILIZER LINK SUB-ASSEMBLY (for RH Side)
HINT
Perform the same procedure as the LH side.
40. REMOVE REAR STABILIZER BAR See: Stabilizer Bar/Service and Repair/Rear Stabilizer Bar/Removal
41. REMOVE REAR PNEUMATIC CYLINDER ASSEMBLY LH (w/ Air Suspension) See: Suspension Control ( Automatic - Electronic )/Air
Spring/Service and Repair/Removal
42. REMOVE REAR PNEUMATIC CYLINDER ASSEMBLY RH (w/ Air Suspension)
HINT
Perform the same procedure as the LH side.
43. REMOVE REAR NO. 2 SUSPENSION ARM ASSEMBLY LH
w/o Air Suspension: See: Control Arm/Service and Repair/Rear Lower Arm/Removal
w/ Air Suspension: See: Control Arm/Service and Repair/Rear Lower Arm/Removal
44. REMOVE REAR NO. 2 SUSPENSION ARM ASSEMBLY RH
HINT
Perform the same procedure as the LH side.
45. SEPARATE FRAME WIRE
(a) Remove the bolt and disconnect the connectors, and then disengage the clamps to separate the frame wire from the rear suspension member
sub-assembly as shown in the illustration.