RX 450h AWD V6-3.5L (2GR-FXE) Hybrid (2011)
NOTICE:
*
Do not twist the rear flexible hose when connecting it.
*
Do not damage the rear flexible hose when reassembling it.
*
If the rear flexible hose is damaged, replace it with a new one.
(b) Install the rear flexible hose LH to the bracket with a new clip.
Text in Illustration
NOTICE:
*
Install the clip as far as it will go.
*
Do not twist the rear flexible hose when installing it.
*
When installing the rear flexible hose, face the identification mark to the outside of the vehicle and minimize twisting of the hose.
(c) Using a union nut wrench, connect the brake line to the rear flexible hose LH.
Torque : 15 Nm (155 kgf-cm, 11 ft-lbf)
NOTICE:
*
Do not bend or damage the brake line.
*
Do not allow any foreign matter such as dirt and dust to enter the brake line.
*
Use the formula to calculate special torque values for situations where the union nut wrench is combined with a torque wrench
See: Service Precautions.
30. INSTALL REAR FLEXIBLE HOSE RH
HINT
Perform the same procedure as the LH side.
31. INSTALL REAR DRIVE SHAFT ASSEMBLY LH (for AWD) See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft
Assembly/Service and Repair/Removal and Replacement/Rear Drive Shaft Assembly/Installation
32. INSTALL REAR DRIVE SHAFT ASSEMBLY RH (for AWD)
HINT
Perform the same procedure as the LH side.
33. INSTALL REAR AXLE SHAFT NUT LH (for AWD) See: Rear Knuckle/Service and Repair/Installation
34. INSTALL REAR AXLE SHAFT NUT RH (for AWD)
HINT
Perform the same procedure as the LH side.
35. INSTALL REAR SPEED SENSOR WIRE LH (for 2WD) See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Wheel
Speed Sensor/Service and Repair/Rear Speed Sensor/Installation
36. INSTALL REAR SPEED SENSOR WIRE RH (for 2WD)
HINT
Perform the same procedure as the LH side.