RX 450h AWD V6-3.5L (2GR-FXE) Hybrid (2011)
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
4. REMOVE INSTRUMENT PANEL GARNISH LH See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Removal
5. REMOVE NO. 1 SWITCH HOLE BASE See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Removal
6. REMOVE HEIGHT CONTROL SWITCH
(a) Disengage the 2 claws to remove the height control switch from the lower instrument panel finish panel sub-assembly.
Installation
SUSPENSION CONTROL: HEIGHT CONTROL SWITCH (for Driver Seat): INSTALLATION
1. INSTALL HEIGHT CONTROL SWITCH
(a) Engage the 2 claws to install the height control switch to the lower instrument panel finish panel sub-assembly.
2. INSTALL NO. 1 SWITCH HOLE BASE See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Installation
3. INSTALL INSTRUMENT PANEL GARNISH LH See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Installation
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
5. INSTALL REAR DECK FLOOR BOX See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Installation
6. PERFORM INITIALIZATION
(a) Perform initialization See: Testing and Inspection/Programming and Relearning/Repair Instruction - Initialization.
7. INSPECT SUSPENSION CONTROL SYSTEM
(a) Inspect the suspension control system See: Suspension Control ( Automatic - Electronic )/Testing and Inspection/Scan Tool Testing and
Procedures/Test Mode Procedure.