RX 450h AWD V6-3.5L (2GR-FXE) Hybrid (2011)
Stabilizer Link: Testing and Inspection
Rear Stabilizer Bar
REAR SUSPENSION: REAR STABILIZER BAR: INSPECTION
1. INSPECT REAR STABILIZER LINK SUB-ASSEMBLY
(a) Hold the rear stabilizer link sub-assembly between aluminium plates in a vise as shown in the illustration.
NOTICE:
Do not overtighten the vise.
(b) As shown in the illustration, move the ball joint stud back and forth 5 times before installing the nut.
(c) Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the fifth turn.
Turning torque:
0.05 to 1.96 N*m (0.510 to 19.8 kgf*cm, 0.443 to 17.3 in.*lbf)
(d) Check for any cracks and grease leaks on the ball joint dust cover.