RX 450h AWD V6-3.5L (2GR-FXE) Hybrid (2011)
Text in Illustration
(g) Fully tighten the 3 nuts.
Torque : 37 Nm (377 kgf-cm, 27 ft-lbf)
(h) Install the bracket cover to the pneumatic chamber bracket with the 4 clips.
(i) Check that the rear pneumatic cylinder cover is not deformed or collapsed inward.
2. INSTALL HEIGHT CONTROL PLUG
(a) Install the height control plug to the rear pneumatic cylinder assembly.
3. INSTALL REAR SPRING SET PLATE
(a) Install the rear spring set plate to the rear No. 2 suspension arm assembly.
NOTICE:
When installing the rear spring set plate, first insert the positioning pin into each hole.
4. INSTALL REAR PNEUMATIC CYLINDER ASSEMBLY
(a) Install 2 new O-rings, a new plate, a new No. 2 connector to the rear pneumatic cylinder assembly.
NOTICE:
Perform this procedure when reusing the rear pneumatic cylinder assembly.
HINT
For the installing procedure of the tube (type 2), refer to Precaution of the suspension control system See: Service
Precautions/Suspension Control System.
(b) Install the rear pneumatic cylinder assembly to the rear No. 2 suspension arm assembly with the nut.