RX 450h AWD V6-3.5L (2GR-FXE) Hybrid (2011)
Removal
SUSPENSION CONTROL: CONTROL VALVE ASSEMBLY (for Front Side): REMOVAL
CAUTION:
Be sure to read Precaution thoroughly before servicing See: Service Precautions/Suspension Control System.
NOTICE:
*
Before removal, make sure to disable vehicle height control by pressing the height control OFF switch and confirming that the
height control OFF indication is displayed on the meter.
*
Check the safety of your surroundings and use caution when disconnecting each height control valve air tube as the air in each
pneumatic cylinder will be discharged and the vehicle body will lower.
*
This operation takes out the air from the front shock absorber, therefore never rotate the lower part of the absorber by turning
the steering wheel etc.
1. PRECAUTION (w/ Navigation System for HDD)
NOTICE:
After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of
memory and settings. As a result, after turning the power switch off, make sure to wait at least 60 seconds before disconnecting the
cable from the negative (-) battery terminal.
2. REMOVE REAR DECK FLOOR BOX See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Removal
3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
4. REMOVE ENGINE ROOM SIDE COVER See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal and
Replacement/Removal
5. REMOVE ENGINE ROOM SIDE COVER LH See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal and
Replacement/Removal
6. REMOVE COOL AIR INTAKE DUCT SEAL See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal and
Replacement/Removal