RX 450h AWD V6-3.5L (2GR-FXE) Hybrid (2011)
(a) Install the rear height control sensor sub-assembly with the 2 nuts.
Torque : 5.0 Nm (51 kgf-cm, 44 in-lbf)
NOTICE:
Do not drop the height control sensor. If the sensor is dropped, replace it with a new one.
(b) Install the height control sensor link to the rear upper control arm with the bolt.
Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)
(c) Install the height control sensor wire harness bracket to the rear suspension member with the bolt.
Torque : 5.0 Nm (51 kgf-cm, 44 in-lbf)
(d) Connect the connector.
2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
3. INSTALL REAR DECK FLOOR BOX See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Installation
4. CHECK VEHICLE HEIGHT
NOTICE:
If the height control sensor link is removed, check the vehicle height.
(a) Change the height control switch from the "NORMAL" position to the "HIGH" position and back to the "NORMAL" position.
(b) Measure the vehicle height See: Alignment/Service and Repair/Front Wheel Alignment ( Service Manual ).
5. ADJUST VEHICLE HEIGHT
NOTICE:
If the height control sensor has been replaced, be sure to adjust the vehicle height.