RX 450h AWD V6-3.5L (2GR-FXE) Hybrid (2011)
Tire Pressure Monitor Receiver / Transponder: Service and Repair
Installation
TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING RECEIVER: INSTALLATION
1. INSTALL TIRE PRESSURE WARNING RECEIVER
(a) Connect the connector.
(b) Engage the 2 tabs into the holes as shown in the illustration to install the tire pressure warning receiver.
(c) Install the bolt.
Torque : 5.0 Nm (51 kgf-cm, 44 in-lbf)
2. INSTALL ROOF HEADLINING ASSEMBLY
HINT
Refer to the procedures from "Install roof headlining assembly" See: Body and Frame/Interior Moulding / Trim/Headliner/Service
and Repair/Removal and Replacement/Installation.
3. INSPECT TIRE PRESSURE WARNING SYSTEM
(a) Inspect the tire pressure warning system See: Testing and Inspection/Scan Tool Testing and Procedures/Test Mode Procedure.