RX 450h AWD V6-3.5L (2GR-FXE) Hybrid (2011)
(b) Remove the bolt and front drive shaft assembly RH from the drive shaft bearing bracket.
NOTICE:
Do not damage the boot or oil seal.
Installation
DRIVE SHAFT / PROPELLER SHAFT: FRONT DRIVE SHAFT ASSEMBLY: INSTALLATION
1. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH
(a) Align the shaft splines and install the drive shaft assembly LH with a brass bar and a hammer.
NOTICE:
*
Set the shaft snap ring with the opening facing down.
*
Be careful not to damage the drive shaft dust cover, boot or oil seal.
*
When inserting the drive shaft assembly, keep it level.
(b) Align the matchmarks and install the front drive shaft assembly LH to the front axle hub sub-assembly.
Text in Illustration
2. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH
(a) Install the front drive shaft assembly RH.
(b) Install a new bearing bracket hole snap ring and the bolt.
Torque : 32 Nm (330 kgf-cm, 24 ft-lbf)
NOTICE:
*
Do not damage the boot or oil seal.
*
When inserting the drive shaft assembly, keep it level.
(c) Align the matchmarks and install the front drive shaft assembly RH to the front axle hub sub-assembly.