RX 450h AWD V6-3.5L (2GR-FXE) Hybrid (2011)
There is play on the nut stopper side (protruding part). Align the center point of the range of the play with the neutral basic line.
(h) Tighten the 2 bolts in the order shown in the illustration.
Torque : 13 Nm (133 kgf-cm, 10 ft-lbf)
(i) Using a screwdriver, stake the nut with the lock plate.
Text in Illustration
(j) Install the control shaft lever, washer and nut.
Torque : 13 Nm (130 kgf-cm, 9 ft-lbf)
(k) Connect the shift lever position sensor connector.
2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY See: Continuously Variable Transmission/Transaxle/Shift Linkage/Shift
Cable/Service and Repair/Installation
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
4. INSTALL REAR DECK FLOOR BOX See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Installation
5. INSPECT SHIFT LEVER POSITION SENSOR POSITION See: Adjustments
6. ADJUST SHIFT LEVER POSITION SENSOR POSITION See: Adjustments
7. INSPECT SHIFT LEVER POSITION See: Continuously Variable Transmission/Transaxle/Shift Linkage/Shift Cable/Adjustments
8. ADJUST SHIFT LEVER POSITION See: Continuously Variable Transmission/Transaxle/Shift Linkage/Shift Cable/Adjustments
9. INSPECT SHIFT LEVER OPERATION See: Continuously Variable Transmission/Transaxle/Shift Linkage/Shift Cable/Adjustments