RX 450h FWD V6-3.5L (2GR-FXE) Hybrid (2010)
NOTICE:
Install the clip as far as it will go.
(b) Using a union nut wrench, connect the brake line to the rear brake flexible hose.
Torque : 15 Nm (155 kgf-cm, 11 ft-lbf)
NOTICE:
*
Do not bend or damage the brake line.
*
Do not allow any foreign matter such as dirt and dust to enter the brake line.
*
Use the formula to calculate special torque values for situations where the union nut wrench is combined with a torque wrench
See: Service Precautions.
(c) Install the rear flexible hose to the flexible hose bracket with the 2 bolts.
Torque : 19 Nm (192 kgf-cm, 14 ft-lbf)
(d) Connect the rear flexible hose to the rear disc brake cylinder assembly with the union bolt and a new gasket.
Torque : 30 Nm (306 kgf-cm, 22 ft-lbf)
3. BLEED BRAKE LINE See: Brake Bleeding/Service and Repair
4. INSTALL REAR WHEEL
Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)
From 08/2009
BRAKE (REAR): REAR BRAKE FLEXIBLE HOSE: INSTALLATION
NOTICE:
*
Because the left and right hoses are not interchangeable, verify the part number when installing the flexible hoses.
*
If the hoses are to be reused, connect them after checking the identification marks placed when each hose was disconnected.
HINT
*
Use the same procedure for the LH side and RH side.
*
The following procedure is for the LH side.
1. INSTALL FLEXIBLE HOSE BRACKET
(a) Install the flexible hose bracket to the rear upper control arm assembly with the bolt.
Torque : 19 Nm (192 kgf-cm, 14 ft-lbf)
2. INSTALL REAR FLEXIBLE HOSE
(a) Install the rear flexible hose to the bracket with a new clip.