Fuel Injector Removal for SC 300 L6-30L (2JZ-GE) (1992)
Fuel Rail Hold-down Bolts
- Install fuel rail mounting bolts finger tight only.
Injector Installation
- Check that injectors rotate smoothly in their bores and electrical connectors are properly orientated.
- Tighten fuel rail bolts.
Torque value - 15 ft.lb (21 Nm)
- Install intake air control valve actuator.
Torque value - 61 in.lbs (6.8 Nm)
Electrical Connector Installation
- Reconnect injector electrical connectors.
- Reverse remainder of REMOVAL procedure to complete.
- Use new gaskets and note the following torque values:
Air chamber supports - 13 ft.lb (18 Nm)
Fuel line to regulator - 20 ft.lb (27 Nm)
Fuel line to fuel rail - 30 ft.lb (42 Nm)
Throttle body - 15 ft.lb (21 Nm)
Throttle body bracket - 15 ft.lb (21 Nm)