SC 400 V8-4.0L (1UZ-FE) (1997)
Remove the 2 distributor rotors.
HINT: Arrange the distributor rotors (No.1 and No.2).
5. REMOVE DISTRIBUTOR HOUSINGS
(a) No.2 Distributor Housing:
Disconnect the camshaft position sensor connector.
(b) Remove the 3 bolts and distributor housing.
Remove the 2 distributor housings.
6. REMOVE CAMSHAFT POSITION SENSORS FROM DISTRIBUTOR HOUSINGS
Remove the bolt. screw and camshaft position sensor.
Remove the 2 camshaft position sensors.
DISTRIBUTOR INSTALLATION
1. INSTALL CAMSHAFT POSITION SENSORS TO DISTRIBUTOR HOUSINGS
Install the camshaft position sensor with the bolt and screw. Install the 2 camshaft position sensors.
Torque: 3.8 N.m (39 kgf.cm. 34 in.lbf)
HINT:
-
The No.1 distributor housing is marked with "L".
-
The No.2 distributor housing is marked with "R".