Mark LT 2WD V8-5.4L (2008)
Rear Seat Backrest
Removal and Installation
All seats
1. Remove the rear seat cushion.
2. Remove the 4 rear seat LATCH bolts and LATCH.
-
To install, tighten to 6 Nm (53 lb-in).
3. Remove the 60/40 retention clip.
4. Remove the center support riser.
60 percent seat
5. Remove the 60 percent support riser bolt.
-
To install, tighten to 33 Nm (24 lb-ft).
6. Remove the 60 percent support riser pivot bolt and bushing.
-
To install, tighten to 33 Nm (24 lb-ft).
7. Remove the left support riser.
8. Remove the 60 percent seat cushion latch handle screw and handle.
9. Remove the 60 percent seat cushion latch cover screw and cover.
10. Remove the 60 percent seat latch cushion bolt and latch.
-
To install, tighten to 26 Nm (19 lb-ft).
11. CAUTION: Use care when separating the seat cushion trim cover from the hook-and-loop strip, or the hook-and-loop strip can be torn