Navigator 4WD V8-5.4L (2010)
Parking Brake Control: Service and Repair
Parking Brake Control
Removal and Installation
1. Relieve tension on the parking brake cable system. For additional information, refer to Parking Brake Cable Tension Release See: Parking Brake
Cable/Service and Repair/Procedures.
2. Remove the front door scuff plate.
3. Remove the instrument panel steering column opening trim panel and if equipped, the instrument panel lower cover. For additional information,
refer to Instrument Panel - Exploded View in Instrument Cluster / Carrier &/or Interior Moulding / Trim.
4. Remove the parking brake release handle bolt.
-
To install, tighten to 3 Nm (27 lb-in).
5. Remove the retainer and the cowl trim panel.
6. Compress the 2 tabs and disconnect the parking brake release cable from the parking brake control assembly.
7. Disconnect the parking brake release cable from the release lever and remove the parking brake release handle.