Navigator 4WD V8-5.4L SOHC VIN 5 (2005)
Trunk / Liftgate Motor: Service and Repair
POWER LIFTGATE MOTOR
Removal and Installation
1. Disconnect the battery ground cable and wait at least one minute.
2. NOTE: RH side shown, LH side similar.
Position the front and rear door seals aside.
3. Remove the C-pillar trim panel.
4. Remove the D-pillar trim panel.
5. CAUTION: To prevent damage to the coat hanger retainer, use a 3/16-inch flat-blade screwdriver for this step.
Remove the four coat hooks.
-
Open the access cover.
-
Insert a screwdriver into the slot and rotate.
6. If equipped with rear climate control, remove the center pin-type retainers.