Navigator 4WD V8-5.4L VIN 5 (2006)
The automatic locking retractor (ALR) feature of the safety belt retractor must be checked by a qualified technician to verify that the ALR feature for a
child safety seat is functioning correctly, in addition to other checks for correct safety belt system function. A new belt and retractor assembly must be
installed if the safety belt assembly's "automatic locking retractor" feature or any other safety belt function is not operating correctly when inspected
according to the functional inspection procedures. Failure to install a new belt and retractor assembly could increase the risk of injury in collisions.
NOTE: The retractor may be equipped with an additional web stop button (small, thin, round button, not to be confused with the larger web stop button)
located on the safety belt webbing. This button is only used for vehicle assembly and serves no other functional purpose. The button can possibly be
retracted under the trim bezel making it difficult to pull the safety belt webbing out of the retractor. To service, remove this web stop button. Do not
install a new safety belt retractor to eliminate this condition. Any resulting appearance concerns with the webbing can be worked out by hand.
All seats
1. Remove the third row 60 percent seat backrest.
2. Remove the safety belt anchor bolt.
-
To install, tighten to 40 Nm (30 lb-ft).
3. Depress the tab and remove the head restraint.
4. Release the J-clip.
5. Release the 2 J-clips.
Manual seat
6. Remove the 2 seat backrest release handle screws and remove the handle and cable assembly.
All seats
7. Remove the safety belt guide.
8. NOTE: The head restraint sleeve pins are not interchangeable, note location for installation.