Navigator 4WD V8-5.4L VIN 5 (2006)
Reach up into the seat backrest, squeeze, release and remove the head restraint sleeves.
9. CAUTION: Use care when separating the seat backrest trim cover from the hook-and-loop strip or the hook-and-loop strip can be torn
from the seat backrest foam.
Invert the seat backrest trim cover and remove.
10. Remove the seat backrest foam pad.
11. Remove the 4 screws from the seat belt cover (2 shown).
12. Remove the safety belt retractor bolt.
-
To install, tighten to 40 Nm (30 lb-ft).
13. Pinch to release the safety belt guide and remove the safety belt retractor.
14. NOTE:
-
Make sure the safety belt webbing is not twisted prior to installation.
-
Remove the shipping clip after safety belt retractor installation.
To install, reverse the removal procedure.
15. Check the active restraint system for correct operation.