3 L4-2.3L (2004)
Front Bumper Reinforcement: Service and Repair
FRONT BUMPER REINFORCEMENT REMOVAL/INSTALLATION
1. Remove the front bumper.
2. Remove the front combination light.
3. Remove the horn.
4. Set the following parts out of the way:
1. Under cover
2. Electric power steering oil pump
3. Washer tank
5. Remove in the order indicated in the table.
CAUTION: If bolt A (only one location on the lower left) is removed, always replace it with the specialized replacement part (Part No.
BPYK 50 0Z2) to ensure proper horn ground connection.
6. Install in the reverse order of removal.
7. After installation, verify that the horn functions normally.
Front Bumper Reinforcement Installation Note
Reusing The Front Bumper Reinforcement
CAUTION: In order to ensure proper body ground connection, do not apply paint in the area where the bolt A flange contacts the front
bumper reinforcement.
