3 L4-2.3L (2004)
8. Measure the resistance between the TR switch terminals B and C.
9. Adjust the switch to the point as follows.
Resistance 750 ohms
10. Tighten the TR switch mounting bolts.
Tightening torque 8 - 11 Nm (82 - 112 kgf-cm, 71 - 97 inch lbs.)
11. Move the selector lever to N position.
12. Verify that the TR switch is aligned with N position.
13. Connect the TR switch connector.
14. Install the clip to the selector cable as shown in the figure.
15. Connect the selector cable to the manual shaft lever as shown in the figure.
16. Inspect the TR switch operation. If there is any malfunction, readjust the TR switch.
17. Install the under cover.
18. Connect the negative battery cable.
19. Install the battery duct and battery cover.
