3 L4-2.3L (2004)
6.
Disconnect ABS speed sensor connector.
7.
Remove ABS speed sensor bracket by removing one (1) 14 mm bolt.
8.
Remove stabilizer link from strut.
9.
Remove tie-rod end ball joint locking pin.
10.
Remove l4mm tie-rod ball joint nut.
11.
Separate ball joint from steering knuckle by tapping lightly with hammer.
12.
Remove 14 mm pinch bolt and nut.
13.
Pull down on lower control arm to separate it from steering knuckle.
14.
Tap drive shaft end lightly with hammer and punch to separate it from steering knuckle. Move steering knuckle if needed to completely separate
from drive shaft.
