3 L4-2.5L (2010)
f. Apply grease to the four points of the slide adjuster as shown.
NOTE:
Apply lithium grease thinly and evenly to the sliding area about 20mm from the edge of shaft hole.
g. Attach a new sub slide unit to the slide adjuster.
NOTE:
To install the push nut, use a 19mm socket (A) and then hit with a hammer from both sides with the assistance of another person. Adjust the clearance
between the push nut and the slide adjuster from 0 to 0.3mm. then slide it to rear end.
Install one nylon washer (A) and two new push nuts (B) at four locations.
