3 L4-2.5L (2010)
Vehicle Speed Sensor: Component Tests and General Diagnostics
VEHICLE SPEED SENSOR (VSS) INSPECTION [FS5A-EL]
On-Vehicle Inspection
1. Inspect the power supply circuit for the VSS.
a. Remove the insulator from the transaxle.
b. Disconnect the VSS connector.
c. Switch the ignition to ON (engine off).
d. Measure the voltage at VSS connector terminal A (harness-side).
-
If there is any malfunction, repair wiring harness between VSS and TCM.
VSS specification
-
4.5-5.5 V
e. Switch the ignition to off.
f.
Connect the VSS connector.
2. Inspect the GND circuit for the VSS.
a. Switch the ignition to off.
b. Measure the voltage at intermediate sensor connector terminal C (harness-side).