3 L4-2.5L (2010)
2. Remove the bearing inner race using a chisel.
With using SST
1. Remove the part as shown in the figure.
2. Position the SSTs and a spare bolt (M10 length 90 mm {3.5 in} or less) as shown in the figure.
CAUTION:
-
When tightening section A, tighten section B securely because the engagement of the SST tab is shallow and it can come off easily.
3. Tighten SST section A until the space between the bearing inner race and wheel hub component is 1-2 mm {0.04-0.07 in}.
4. Temporarily loosen SST section A and position the SST again.