3 L4-2.5L (2010)
-
Install the SST using a piece of clean rag to prevent the coil spring from being scratched.
a. Set the SST attachments (tabs) to the positions shown in the figure.
b. Install the front shock absorber and coil spring to the SST so that the coil spring is set to the position shown in the figure.
2. Compress the coil spring using the SST.
3. Remove the piston rod nut.
Coil Spring Installation Note
1. Compress the coil spring using the SSTs.
2. Install the shock absorber so that the lower end of the coil spring is seated on the step of the lower spring seat.
Dust Boot Installation Note
1. Install the dust boot by hooking the bottom edge over the shock absorber lip.
Bearing Installation Note
1. Install the bearing by hooking the upper end of the dust boot to the bearing lip.
