3 L4-2.5L (2010)
Shift Interlock: Component Tests and General Diagnostics
KEY INTERLOCK SYSTEM INSPECTION
Key Interlock System Inspection
1. Switch the ignition to ON.
2. Perform the following procedures to inspect the key interlock system.
-
If there is any malfunction, inspect the key interlock solenoid and NOT P position switch.
a. Verify that the ignition cannot be switched to off when the selector lever is not in the P position.
b. Verify that the ignition can be switched to off when the selector lever is in the P position.
Key Interlock Solenoid Inspection
1. Perform the following procedures.
a. Remove the battery cover. See: Starting and Charging/Battery/Service and Repair/Removal and Replacement
b. Disconnect the negative battery cable.
c. Remove the column cover. See: Steering and Suspension/Steering/Steering Column/Steering Column Cover/Service and Repair
d. Disconnect the key interlock solenoid connector.
2. Measure the resistance between the key interlock solenoid terminals A and B.
-
If there is any malfunction, replace the steering lock. See: Steering and Suspension/Steering/Steering Column/Service and Repair/Steering
Wheel And Column Removal/Installation - Without Advanced Keyless Entry And Push Button Start System
Key interlock solenoid specification
-
Approx.36 ohms
NOT P Position Switch Inspection
1. Perform the following procedures.
a. Remove the battery cover. See: Starting and Charging/Battery/Service and Repair/Removal and Replacement
b. Disconnect the negative battery cable.
c. Remove the console. See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Console Removal/Installation
d. Disconnect the selector lever component connector.
