3 L4-2.5L (2010)
c. Install the selector cable end (transaxle side) to the manual shaft lever as shown in the figure.
6. Verify that the selector cable is securely installed.
7. Adjust the selector cable.
Bulb Removal/Installation
1. Remove the battery cover. See: Starting and Charging/Battery/Service and Repair/Removal and Replacement
2. Disconnect the negative battery cable.
3. Remove the upper panel. See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Upper Panel Removal/Installation
4. Remove the knob.
5. Remove the shift panel and indicator panel as a single unit.
a. Release the hooks securing the shift panel and console, and then release the hooks securing the shift panel and ashtray panel. (See See: Body
and Frame/Interior Moulding / Trim/Console/Service and Repair/Shift Panel Removal/Installation)
b. Lift up the shift panel and indicator panel and disconnect the bulb socket from the indicator panel.
c. Remove the shift panel and indicator pane from the selector lever as a single unit.
6. Remove the bulb from the bulb socket.
