3 L4-2.5L (2010)
5. Gradually tighten the flywheel lock bolts in a crisscross pattern.
Tightening torque
-
152-161 Nm {15.5-16.4 kgf-m, 113-118 ft-lbf}
Pilot Bearing Installation Note
1. Use the SSTs to install the pilot bearing.
2. As shown in the figure, press-fit the pilot bearing to the position which is 4.0-5.0 mm {0.16-0.19 in} from the crankshaft end.
Clutch Disc Installation Note
1. Clean the splines of the clutch disc and the main drive gear with a brush.
2. Spread a thin layer of clutch grease on the splines.
3. Hold the clutch disc position using the SST.
Clutch Cover Installation Note
1. Install the SSTs.