3 L4-2.5L (2010)
Fluid - M/T: Testing and Inspection
Transaxle Oil Inspection [G35M-R]
TRANSAXLE OIL INSPECTION [G35M-R]
1. Park the vehicle on level ground.
2. Remove the aerodynamic under cover No.2. See: Body and Frame/Splash Guard/Service and Repair/Aerodynamic Under Cover No.2
Removal/Installation
3. Remove the oil level plug and washer.
4. Verify that the oil is near the brim of the plug port.
-
If the oil level is lower than the low level, add the specified amount and type of oil through the oil level plug hole.
Manual transaxle oil Grade
-
API GL-4
Manual transaxle oil Viscosity
-
SAE 75W-80
5. Install a new washer and the oil level plug.
Tightening torque
-
39-59 Nm {4.0-6.0 kgf-m, 29-43 ft-lbf}
6. Install the aerodynamic under cover No.2. See: Body and Frame/Splash Guard/Service and Repair/Aerodynamic Under Cover No.2
Removal/Installation