323 L4-1600 1597cc (1986)
Transmission Position Switch/Sensor: Testing and Inspection
Neutral Switch - A/T
Fig. 25 Connecting A Circuit Tester To Neutral Switch, A/T.
1.
Position the vehicle on a rolling road tester or equivalent.
NOTE: Secure vehicle so as not to allow it to roll forward or to slide.
2.
Disconnect the neutral switch connector.
3.
Connect a circuit tester to the neutral switch terminal and ground, Fig. 25 and then check the continuity between the switch terminal and ground.
Fig. 26 Neutral Switch Continuity Chart, A/T.
4.
Increase vehicle speed to about 9 mph (15 km/h). Compare the conditions in Fig. 26.