mazda Workshop Repair Guides

Mazda Workshop Service and Repair Manuals

Passenger Assist Handle > < Glove Compartment|Service and Repair|Page 7132
Page 1
background image

Headliner: Service and Repair

HEADLINER REMOVAL/INSTALLATION

1. Remove the battery cover.
2. Disconnect the negative battery cable.
3. Partially peel back the seaming welt.
4. Remove the following parts:

1. A-pillar trim
2. Front scuff plate inner
3. Rear scuff plate
4. B-pillar lower trim
5. Front seat belt upper anchor installation bolt
6. B-pillar upper trim
7. Rear package tray lid
8. Sub-trunk
9. Third-row seat

10. Rear header trim
11. Trunk end trim
12. Third-row seat belt lower anchor installation bolt
13. Cargo compartment light
14. Trunk side trim
15. Second-row seat belt upper anchor installation bolt
16. C-pillar trim
17. Map light
18. Assist handle
19. Sunvisor

5. Disconnect the roof wiring harness connector and detach the roof wiring harness connector clip from the body.
6. Disconnect the rear washer hose.
7. Disconnect the antenna feeder.
8. Remove the sunroof seaming welt, (vehicles with sunroof)
9. Remove the fasteners.

10. Take the headliner out from the opened liftgate.
11. Install in the reverse order of removal.

Passenger Assist Handle > < Glove Compartment|Service and Repair|Page 7132