5 L4-2.3L (2007)
Trim Panel: Service and Repair
Pillar Trim
A-Pillar Trim Removal/Installation
A-PILLAR TRIM REMOVAL/INSTALLATION
1. Partially peel back the seaming welt.
2. Remove clips A using a fastener remover.
3. Pull the A-pillar trim outward and remove clip B from the grommet (1).
4. Slide the A-pillar trim upward and remove clip B from the A-pillar trim (2).
5. Pull clip B out and rotate it 45°.
6. Pull clip B and remove it from the grommet.
7. Install clip B to the A-pillar trim.
8. Install in the reverse order of removal.
B-Pillar Lower Trim Removal/Installation
B-PILLAR LOWER TRIM REMOVAL/INSTALLATION
1. Remove the front scuff plate inner.
2. Remove the rear scuff plate.
3. Partially peel back the seaming welt.
