5 L4-2.3L (2007)
1. Remove the cylinder block lower blind plug.
2. Install the SST.
3. Turn the crankshaft clockwise the crankshaft is in the No.1 cylinder TDC position (until the balance weight is attached to the SST).
4. Hold the crankshaft pulley using the SSTs.
No.3 Engine Mount Rubber Removal Note
1. Remove the following parts to install the SST.
1. Air cleaner assembly
2. Windshield wiper arm and blade
3. Cowl grille
4. Cowl panel
5. No. 1 reserve tank with the hoes still connected and position the No. 1 reserve tank aside so that it is out of the way
6. Reserve tank bracket
2. Install the SST using the following procedure.
1. Align the rear support rod hole of the SST to the shock absorber upper bolt.
