5 L4-2.3L (2007)
Air Bag Control Module: Service and Repair
Curtain Air Bag Module
CURTAIN AIR BAG MODULE REMOVAL/INSTALLATION
WARNING: Handling the air bag module improperly can accidentally deploy the air bag module, which may seriously injure you. Read the
air bag system service warnings and cautions before handling the air bag module.
1. Turn the ignition switch to the LOCK position.
2. Remove the battery cover.
3. Disconnect the negative battery cable and wait for 1 min or more.
4. Remove the following parts.
1. A-pillar trim
2. Front scuff plate inner
3. Rear scuff plate
4. B-pillar lower trim
5. Front seat belt upper anchor installation note
6. B-pillar upper trim
7. Rear package tray lid
8. Third-row seat
9. Rear header trim
10. Trunk end trim
11. Third-row seat belt lower anchor installation note
12. Cargo compartment light
13. Trunk side trim
14. Second-row seat belt upper anchor installation note
15. C-pillar trim
16. Map light
17. Sunvisor
18. Assist handle
19. Headliner
20. Rear speaker
5. Remove in the order indicated in the table.
6. Install in the reverse order of removal.
7. When the ignition switch is turned to the ON position verify that the air bag system warning light illuminates for approx. 6 s and goes out.
-
If the air bag system warning light does not operate normally, refer to the on-board diagnostic system (air bag system) and perform inspection
of the system.
Connector Removal Note
