5 L4-2.3L (2007)
7. Loosen the TR switch mounting bolts.
8. Measure the resistance between the TR switch terminals B and C.
9. Adjust the switch to the point as follows.
Resistance
750 ohms
10. Tighten the TR switch mounting bolts.
Tightening torque
8-11 Nm (82-112 kgf.cm, 71-97 in.lbf)
11. Move the selector lever to N position.
12. Verify that the TR switch is aligned with N position.
13. Connect the TR switch connector.
14. Install the clip to the selector cable as shown in the figure.