5 L4-2.3L (2007)
Back Window Glass: Service and Repair
REAR WINDOW GLASS REMOVAL
1. Remove the battery cover.
2. Disconnect the negative battery cable.
3. Remove the rear wiper arm and blade.
4. Remove the liftgate trim.
5. Remove the rear wiper motor.
6. Remove the high-mount brake light.
7. Disconnect the filament connector.
8. Apply protective tape along the edge of the body.
NOTE: Overlap and adhere the protective tape to the corners to prevent damage.
9. Insert the SST (piano wire), which has been cut to sufficient length from inside the vehicle.
WARNING: Using the SST (piano wire) with bare hands can cause injury. Always wear gloves when using the SST (piano wire).
NOTE: Before removing the rear window glass from the body, mark the position of the glass by affixing tape to the glass and body panel.
10. Wind each end of the SST (piano wire) around a bar.
NOTE: Use a long sawing action to spread the work over the whole length of the SST (piano wire) to prevent it from breaking due to localized
heating.
11. Secure one end of the SST (piano wire), and while pulling the other end, cut the sealant around the rear window glass.
12. Remove the rear window glass.