6 L4-2.5L (2010)
Not using M-MDS
3. Perform the setting procedure and the customization settings.
Using M-MDS
1. Connect the M-MDS to the DLC-2.
2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
-
When using the IDS (laptop PC)
1
Select "DataLogger".
2
Select "Modules".
3
Select "BCM/GEM".
-
When using the PDS (Pocket PC)
1
Select "Module Tests".
2
Select "BCM/GEM".
3
Select "DataLogger".
3. Select the PART#_PFX
4. Verify the PID data according to the directions on the screen.
Not using M-MDS
1. Remove the front scuff plate (driver-side). See: Body and Frame/Interior Moulding / Trim/Scuff Plate/Service and Repair/Front Scuff Plate
Removal/Installation
2. Remove the front side trim (driver-side). See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Front Side Trim
Removal/Installation
3. Disconnect the connector at the position shown in the figure.