6 L4-2.5L (2010)
Blind Spot Indicator: Testing and Inspection
BLIND SPOT MONITORING (BSM) INDICATOR LIGHT INSPECTION
1. Disconnect the negative battery cable.
2. Remove the inner garnish. See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Front Door Panel/Service and Repair/Removal and
Replacement/Inner Garnish Removal/Installation
3. Apply battery voltage to power outer mirror terminal G, and terminal B to ground.
4. Verify that the BSM indicator light illuminates.
-
If the light dose not illuminate, go to the next step.
5. Remove the outer mirror glass. See: Body and Frame/Mirrors/Service and Repair/Outer Mirror Glass Removal See: Body and
Frame/Mirrors/Service and Repair/Outer Mirror Glass Installation
6. Inspect for proper BSM indicator light connector connections, connection conditions, damage, corrosion, or deformation.
-
If there is any malfunction, replace the power outer mirror or outer mirror glass.
7. Apply battery voltage to BSM indicator light terminal A, and terminal B to ground.
8. Verify that the BSM indicator light illuminates.
-
If the light dose not illuminate, replace the outer mirror glass. See: Body and Frame/Mirrors/Service and Repair/Outer Mirror Glass Removal
See: Body and Frame/Mirrors/Service and Repair/Outer Mirror Glass Installation
-
If the light dose illuminate, go to the next step.
9. Verify that the continuity between the power outer mirror terminals is as indicated in the table.