6 L4-2.5L (2010)
Navigation Display: Service and Repair
CAR-NAVIGATION UNIT REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the following parts:
a. Upper panel See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal and Replacement/Upper Panel
Removal/Installation
b. Decoration panel See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Removal and
Replacement/Decoration Panel Removal/Installation
c. Shift knob (MTX) See: Transmission and Drivetrain/Manual Transmission/Transaxle/Shifter M/T/Service and Repair
d. Shift panel See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal and Replacement/Shift Panel
Removal/Installation
e. Center panel lower See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Removal and
Replacement/Center Panel Lower Removal/Installation
f.
Center panel upper See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Removal and
Replacement/Center Panel Upper Removal/Installation
g. Climate control unit See: Heating and Air Conditioning/Control Assembly/Service and Repair/Climate Control Unit Removal/Installation -
Full-Auto Air Conditioner See: Heating and Air Conditioning/Control Assembly/Service and Repair/Climate Control Unit
Removal/Installation - Manual Air Conditioner
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
CAUTION:
-
When installing the car-navigation unit, make sure that the wiring harness and antenna feeder are not caught between the unit and dashboard. If
the wiring harness or the antenna feeder is caught between the unit and dashboard, it may cause malfunctions.