6 L4-2.5L (2010)
Seat Heater Control Module: Service and Repair
SEAT WARMER MODULE REMOVAL/INSTALLATION
WARNING:
-
Handling a front seat (with built-in side air bag) improperly can accidentally operate (deploy) the air bag, which may seriously injure you. Read
the service warnings before handling a front seat (with built-in side air bag). See: Restraint Systems/Air Bag Systems/Service Precautions/Air Bag
System Service Warnings
CAUTION:
-
After removing a front seat, do not operate the slider lever. If the slider lever is operated, the left and right slide positions will deviate, and the
slide adjuster may be damaged after the front seat is installed.
-
Verify that there are no malfunctions in the sliding mechanism after installing a front seat.
-
When performing the procedure with a front seat removed from the vehicle, perform the procedure on a clean rag so as not to damage or soil the
seat.
-
If any of the following work is performed, perform the seat weight sensor calibration using the M-MDS. See: Restraint Systems/Air Bag
Systems/Seat Occupant Sensor/Adjustments
-
Replacement with a new seat weight sensor
-
Replacement with a new seat weight sensor control module
-
Replacement with new passenger-side seat par
-
Disassembly of the passenger-side seat
-
If any of the following work is performed, perform the seat weight sensor inspection using the M-MDS. See: Restraint Systems/Air Bag
Systems/Seat Occupant Sensor/Testing and Inspection
-
Removal of the passenger-side seat
-
Loosening and retightening of passenger-side seat fixing bolts
CAUTION:
-
After removing a front seat, do not operate the slider lever. If the slider lever is operated, the left and right slide positions will deviate, and the
slide adjuster may be damaged after the front seat is installed.
-
Verify that there are no malfunctions in the sliding mechanism after installing a front seat.
-
When performing the procedure with a front seat removed from the vehicle, perform the procedure on a clean rag so as not to damage or soil the
seat.
1. Disconnect the negative battery cable and wait 1 min or more.
2. Remove the front seat. See: Seats/Service and Repair/Removal and Replacement
3. Detach the clip by squeezing it at the positions indicated by the arrows (1) shown in the figure, and press the clip in the direction of the arrow (2)
to remove the seat warmer module.
