6 L4-2.5L (2010)
Seat Heater: Service and Repair
SEAT WARMER UNIT REMOVAL/INSTALLATION
Removal
WARNING:
-
Handling a front seat (with built-in side air bag) improperly can accidentally operate (deploy) the air bag, which may seriously injure you. Read
the service warnings before handling a front seat (with built-in side air bag). See: Restraint Systems/Air Bag Systems/Service Precautions/Air Bag
System Service Warnings
CAUTION:
-
After removing a front seat, do not operate the slider lever. If the slider lever is operated, the left and right slide positions will deviate, and the
slide adjuster may be damaged after the front seat is installed.
-
Verify that there are no malfunctions in the sliding mechanism after installing a front seat.
-
When performing the procedure with a front seat removed from the vehicle, perform the procedure on a clean rag so as not to damage or soil the
seat.
-
If any of the following work is performed, perform the seat weight sensor calibration using the M-MDS. (See See: Restraint Systems/Air Bag
Systems/Seat Occupant Sensor/Adjustments)
-
Replacement with a new seat weight sensor
-
Replacement with a new seat weight sensor control module
-
Replacement with new passenger-side seat par
-
Disassembly of the passenger-side seat
-
If any of the following work is performed, perform the seat weight sensor inspection using the M-MDS. (See See: Restraint Systems/Air Bag
Systems/Seat Occupant Sensor/Testing and Inspection)
-
Removal of the passenger-side seat
-
Loosening and retightening of passenger-side seat fixing bolts
1. Switch the ignition to off.
2. Disconnect the negative battery cable and wait 1 min or more.
3. Remove the following parts:
a. Front seat See: Service and Repair/Removal and Replacement
b. Front seat side cover See: Service and Repair/Overhaul/Front Seat Side Cover Removal/Installation
c. Front seat back component See: Seat Back/Service and Repair/Overhaul/Front Seat Back Component Removal/Installation
d. Front seat back trim See: Seat Back/Service and Repair/Removal and Replacement
e. Front seat cushion trim See: Service and Repair/Overhaul/Front Seat Cushion Trim Removal/Installation
4. Peel off the seat warmer unit from the position of the arrow shown in the figure.